Surrey · Heat pump installation
Air Source Heat Pumps in Ripley
Expert air source heat pumps for Ripley: a survey or diagnosis, a fixed price, careful work and proper paperwork. Ask us for a fixed-price quote.
- Checking eligibility for a heat pump grant
- Planning and permitted development questions
- Checking emitters for a heat pump
Air source heat pumps for homes and businesses in Ripley
Hot water from an air-to-water system is stored in a cylinder. If you have a combi boiler and no cylinder, the survey looks at where one could go. With air-to-air, hot water has to come from something else. Typical jobs include questions about the Boiler Upgrade Scheme and finding a place for the outdoor unit, across hot water cylinders, air-to-water heat pumps and homes heated by oil, LPG or gas.
In a place like Ripley, some homes are listed, because permitted development does not apply within the grounds of a listed building, so we check consent first.
Nothing is signed off by word of mouth: commissioning details and F-Gas records for a new system, a note of the fault and the fix for a repair, or a service record. File it with the manual, because it helps with any later warranty question.
- Where
- Ripley (GU23)
- Region
- Surrey
- Price guide
- £8,000–£16,000 before the grant, 0% VAT on homes
- Price
- Fixed-price quote after a site survey
- Replies
- On the working day you ask
- Approvals
- F-Gas certified, NICEIC approved, MCS
- Telephone
- 07833 053749
- Updated
- 30 October 2026
FAQs for Ripley
Is the heat pump grant available in Ripley?
Ripley is covered, as the scheme runs across England and Wales. Air-to-water and ground source systems attract £7,500. Air-to-air gets £2,500, but only where it takes over from fossil-fuel heating and covers the whole home’s heating demand. The installer applies, and we are MCS certified.
Will you come out to Ripley?
Yes, smaller places are covered as well as towns. A few photos and the postcode are enough to get things started.
What accreditations do you have?
As the law requires for refrigerant work, we are an F-Gas certified company. NICEIC approval, MCS certification for heat pumps and Checkatrade membership sit alongside it.
Do you work on commercial properties?
Yes. From a single let flat to offices, shops and public buildings, we work the same way: survey or diagnosis, a fixed price and proper paperwork.
Is a heat pump permitted development?
It depends on the property and where the unit goes. Flats have different limits, conservation areas have extra conditions, and an Article 4 direction can remove the rights, so we check during the survey.
Which brands do you work with?
Mitsubishi Electric, Daikin, Fujitsu, Panasonic, Toshiba, LG, Samsung, Mitsubishi Heavy Industries, Hitachi and others. For new systems, we recommend a brand and model to suit the job and explain why.
What does F-Gas certified mean?
Anyone installing, repairing or servicing the refrigerant side must be qualified, and their company certified. It’s worth checking before booking and we’ll gladly show you ours.
Fixed-price quotes for air source heat pumps in Ripley
Some jobs are bigger than they look, and some smaller. What affects the quote:
- The brand, model and parts involved
- Whether it’s a simple split or a larger system
- Whether it’s a one-off job or part of a maintenance contract
The pipe route, the height of the units and how we reach them all affect the cost. We take each of them into account and give you a fixed price before any work starts.
What to send for a quote
Before you ask for a quote, gather:
- A short video of any fault, such as a noise or a flashing light
- A few photos of the room and the wall the unit is on, or will go on
- Your consumer unit or fuse board
Photos are the fastest route to a quote: the inside and outside of the property where the work is, plus the rating plate of any unit already there. Add the address and what you’d like done, and many jobs can be priced from that.
Air source heat pumps around Ripley
About 82% of households live in detached or semi-detached houses, according to the last census (2021). Detached and semi-detached houses typically have room for the outdoor unit and a cylinder. Roughly a third of a mile or less from central Ripley, you reach the Ripley Conservation Area. Draw a one-mile circle round the middle of Ripley and it takes in 4 conservation areas. Church of St Mary the Virgin, listed at grade II*, is one of roughly 40 protected buildings and structures in the half-mile around Ripley’s centre. So the heat pump survey asks two extra questions here: is the home listed, and is it inside a conservation area?
Byfleet Manor lies about 2.6 miles north-east. Owners of listed homes need consent before a heat pump is fitted, so it’s one of our first questions.
Ripley is about 4 miles east of Woking, in Surrey. Whether you are in the middle of Ripley or further out, our engineers cover air source heat pumps, from a single room to a whole building. We cover 395 places across Surrey, from busy centres to quieter spots.
Our nearest recent job to Ripley was on Goldsworth Road, Woking (GU21), about 4 miles west: installing a Daikin Perfera wall-mounted unit in the open-plan living area.
Main roads around Ripley include the B2215, which makes travel easy. Our engineers work on High Street, Dorton Way and Wentworth Close and the roads around them. Close by, we work in Ockham (2 miles east), West Horsley (3 miles south-east), East Clandon (3 miles south), East Horsley (3 miles south-east) and Effingham (5 miles south-east). Within a short drive, we also cover Guildford (5 miles south-west), Woking (4 miles west), Camberley (10 miles west) and Epsom (10 miles east).
Near you in Ripley
Locally, jobs take us to houses, flats and workplaces close to The Anchor Public House and St John the Baptist Catholic Comprehensive School, among other places. The nearest railway station is Clandon station, about 2.5 miles south. Other landmarks nearby include The Peacocks (3 miles north-west) and Woking Community Hospital (2.8 miles west). For a walk, there’s Papercourt Marshes and Boldermere Lake.
What happens on the day
Refrigerant work is done by qualified engineers working for an F-Gas certified company, and electrical work is done by us as NICEIC approved contractors. So on the day, you do not need a separate electrician for the electrical side. The work takes a few days on site, depending on the cylinder, the radiators and the pipework involved. A note on how to find the property and where to park makes a visit to Ripley easier.
- We find out about your home and the heating you have now.
- We measure heat loss for every room.
- The design covers the heat pump, emitters, hot water and outdoor unit.
- A fixed-price quote explains the cost, the grant position and the VAT.
- Installation, commissioning and MCS registration complete the job.
Before we arrive
- Clear the space around the indoor unit, or where it will go
- Name a contact who can meet us at the agreed time
- Mention any roof access, ladders or high-level work
How to get a quote
If you need air source heat pumps in Ripley, ring 07833 053749 or use the quote form. Tell us what kind of property it is and what you’d like done, and send a few pictures if you can. We reply the same working day.
Read more
Common problems we fix in Ripley
An ageing boiler is often the moment people start thinking about a heat pump. Planning the change before the boiler fails gives you time to survey, design and apply for any grant instead of making a rushed decision when the heating stops.
The things we’re asked about most include:
- Choosing between air-to-water and air-to-air
- Questions about where the outdoor unit can go
- Questions about listed buildings or conservation areas
Older homes near Church of St Mary Magdalen may need extra checks for planning and heat loss before a heat pump is designed.
What your quote should include
- Exactly what the price includes, from supply and fitting to commissioning
- Whether the manufacturer’s warranty depends on regular servicing
- Which VAT rate the quote uses, and why
Owner checks or an engineer?
On air conditioning, the filters in the indoor unit are normally the one part owners can clean, if the manual says so. They come out, get a gentle clean and go back only when they’re dry. For a heat pump, the main owner jobs are a clear outdoor unit and sensible control settings.
Don’t move, re-route or disconnect units or pipework yourself. Moving a unit involves the refrigerant circuit, so it needs an F-Gas qualified engineer, and the electrics need care too. Ask us to quote for a move instead.
Places near Ripley
More services for Ripley
What a customer said
“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”
Sarah M., East Grinstead