Kent · Heat pump installation
Bearsted air source heat pumps
Air source heat pumps for Bearsted, from F-Gas certified engineers, with warranty terms explained brand by brand. We reply to enquiries the same working day.
- Questions about listed buildings or conservation areas
- Deciding on the outdoor unit position
- Questions about the Boiler Upgrade Scheme
How we handle air source heat pumps in Bearsted
We begin with a room-by-room heat loss survey. It shows how much heat each room needs on a cold day so the system is sized to match. Guesswork leads to systems that are too big or too small. If the problem is moving away from fossil-fuel heating and questions about where the outdoor unit can go, we can sort it out.
Cottages and older homes near Bearsted can lose heat faster, which a heat loss calculation will show. Sometimes insulating first makes more sense.
Refrigerant work is written up in the F-Gas records: what was done, the refrigerant type and any amount added or recovered. Keep the records with the manual and the warranty documents, as a manufacturer or a future engineer may ask to see them.
- Location
- Bearsted (ME14, ME15)
- Region
- Kent
- Price guide
- Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
- Approvals
- F-Gas certified company, NICEIC approved, MCS
- Quotes
- Fixed-price quote after a site survey
- Call
- 07833 053749
- Last updated
- 30 October 2026
What affects the cost of air source heat pumps
Some jobs are bigger than they look, and some smaller. The main factors:
- What state the existing equipment is in
- Whether it’s a one-off job or part of a maintenance contract
- What kind of system it is
No two properties are the same, so we price each one individually. The equipment, how we reach it, the route between units and the work needed all play a part.
Before you get in touch
When you call or email, these details help:
- Your consumer unit or fuse board
- Wide photos of the room or the existing unit
- A short video of any fault, such as a noise or a flashing light
Quotes don’t take long. Send a few details and photos, and we reply the same working day. If we need to see the property first, we book a survey at a time that works for you.
The process
Think of the visit in three stages: look, put right and sign off. First we check the system or the space against the plan, then we do the work, and finally we test, record and explain. Most of the time goes on the middle part, and that takes anything from a couple of days for air-to-air to the best part of a week for air-to-water with radiator changes. Everything the job in Bearsted needs is worked out beforehand.
- We talk through your home, your current heating and what you want from a heat pump.
- On the visit we calculate what every room loses on a cold day, then check the radiators, room for a cylinder and outdoor unit options.
- We send a fixed-price quote that shows the equipment, the grant position and the VAT.
- The outdoor unit, the indoor equipment and the controls are installed and connected.
- The system is commissioned and registered under MCS, and we show you how to use it.
Preparing for the visit
- Let us know where we can park and unload
- Let us know where the consumer unit is
- Mention any roof access, ladders or high-level work
Get a fixed-price quote
If you need air source heat pumps in Bearsted, ring 07833 053749 or email us. Let us know the type of property and what you need, plus some photos if they’re to hand. We reply the same working day.
Read more
Why act early in Bearsted
Planning rules have specific conditions. We look at the planning position early, so there are no surprises, including conservation areas, listed buildings and Article 4 directions. A system that’s left with a fault, or without a service, normally costs more to run.
The price reflects the work, not guesswork. That is why we look at the job first, from pictures or on a survey, and the price is agreed before any work starts.
Why book with us
- Mitsubishi Electric, Daikin, Fujitsu, Panasonic, Toshiba and more
- Covering London and the South East
- Fixed-price quotes after a survey or photos
- Checkatrade member
Take a look at our cost guide or our accreditations and certificates.
Also near Bearsted
What else we do in Bearsted
Bearsted: your questions answered
Is planning permission needed for a heat pump in Bearsted?
The answer turns on the property and where the outdoor unit would sit. The Bearsted Conservation Area is close to the centre of Bearsted. A heat pump on a house can be permitted development if it meets the conditions, including the MCS noise check, but not within the grounds of a listed building, and in a conservation area the outdoor unit can’t face a road. Where necessary, we check with Maidstone council, which is normally the planning authority for Bearsted.
Is the heat pump grant available in Bearsted?
Bearsted is in England, where the Boiler Upgrade Scheme runs. Whether your home qualifies, and for how much, depends on the type of heat pump and the heating it replaces. We hold MCS certification, so the application is ours to make for you.
Whose job is it to check the system for leaks?
The operator of the equipment, working with qualified engineers. Larger systems need regular checks: at least every 12 months from 5 tCO2e and every 6 months from 50 tCO2e. We can tell you which band your system falls into.
When will I hear back?
On the same working day you contact us. After that, we agree a survey, diagnosis or installation date that suits you, and you get a fixed price before any work goes ahead.
How much time does a heat pump install need?
An installation takes from a couple of days to around a week, depending on the system and how much of the heating changes. We confirm the timing after the survey, and you can phone 07833 053749 or send an email to book it.
Do you provide F-Gas records?
Yes. It’s the record a manufacturer or the next engineer will ask to see: the date, the work, and any refrigerant added or recovered.
Can I do any of the installation myself?
Not the refrigerant work. Under the F-gas rules, it must be done by qualified engineers from a certified company, and a new circuit is notifiable under Part P unless a registered electrician, such as a NICEIC approved contractor, does it.
Air source heat pumps around Bearsted
Valuation Office Agency council tax records date about 43% of homes in the Bearsted area to the post-war years, 1945 to 1972, and about 78% of households live in detached or semi-detached houses, according to the last census (2021). Homes of that age often have cavity walls that may or may not be insulated, which the survey checks. Detached and semi-detached houses usually have room for the outdoor unit and a cylinder.
Homeowners near Bearsted station often ask whether a heat pump can take over from the boiler, and the heat loss survey answers that. Stoneacre, roughly 1.3 miles south, is a reminder to check your home’s listing status: permitted development does not cover listed buildings.
Bearsted is about 2 miles east of Maidstone, in Kent. Wherever you are in the ME14 postcode area, we can help with air source heat pumps. 922 places in Kent are on our list. Bromley, roughly 26 miles off, has its own page on this site.
We cover every part of the ME14 and ME15 postcode area for air source heat pumps. Our engineers work on The Street, Tower Lane and Roseacre Lane and the roads around them. Close to Bearsted, our area also takes in Weavering (1 mile west), Grove Green (1 mile north-west), Caring (1 mile south-east), Thurnham (1 mile north-east) and Willington (2 miles south-west). Larger places within reach include Sittingbourne (9 miles north-east), Gravesend (14 miles north-west), Tonbridge (14 miles west) and Faversham (14 miles east).
Around Bearsted
Typical jobs here are in properties near Mote Park, Valley Park School and The Kentish Yeoman pub and the streets around them. There’s a railway station in Bearsted itself: Bearsted station. Nearby you’ll also find KIMS hospital (1.2 miles north-west) and The Mall Maidstone (2 miles west). Not far away are Detling Hill.
What air source heat pumps can’t fix
Air source heat pumps cannot fix everything, and we will tell you before any work starts. It doesn’t solve:
- Disconnecting or servicing a gas boiler
- Improving the building’s insulation
- Promising eligibility for the Boiler Upgrade Scheme
Not sure which it is? You can phone 07833 053749 or use the quote form and we will tell you honestly before you book.
Parts of the system we cover
- Hot water cylinders
- Underfloor heating
- Air-to-air heat pumps
- Air-to-water heat pumps
- Homes heated by oil, LPG or gas
- Radiator systems
From one of our customers
“Very professional from the initial survey through to installation. The engineer explained everything clearly and the quote was exactly what we paid. Would not hesitate to recommend AirCon Doctor.”
David W., Haywards Heath