Kent · Heat pump installation
Heat pump installation in Tankerton, Kent
We cover Tankerton for heat pump installation. Diagnosis first, a fixed price and proper paperwork when we finish.
- Questions about where the outdoor unit can go
- Deciding which kind of heat pump suits the home
- Replacing a combi boiler with a heat pump
Air source heat pumps in Tankerton
Until 31 March 2027, a heat pump installed in residential accommodation carries 0% VAT, with 5% from 1 April 2027. That follows HMRC Notice 708/6, and it doesn’t apply to businesses. For air-to-air systems, we confirm the VAT on your quote. Please treat this as general information rather than tax advice. If you are dealing with comparing heat pump types and finding a place for the outdoor unit, we can sort it out.
Older homes around Tankerton can be draughty or have solid walls, so a proper heat loss calculation matters. Sometimes insulating first makes more sense.
Think of the paperwork as the system’s health record: what was fitted or found, what was done and when. It makes the next visit quicker and any warranty question simpler and it’s worth keeping safe.
- Location
- Tankerton (CT5)
- Wider area
- Kent
- Approvals
- F-Gas certified, NICEIC approved, MCS
- Price guide
- £8,000–£16,000 (0% VAT on homes), before the grant
- Quote
- Fixed after a survey or pictures
- Call
- 07833 053749
- Page updated
- 30 October 2026
Tankerton questions
Do I need planning permission for a heat pump in Tankerton?
It comes down to the building and the spot chosen for the outdoor unit. Central Tankerton is a short walk from the Tankerton Conservation Area. On a house, an air source heat pump can often go ahead under permitted development, with an outdoor unit of no more than 1.5 cubic metres and an installation that meets MCS 020(a), which includes a noise check. Those rights don’t reach the grounds of a listed building, and conservation areas rule out walls or roofs facing a road. If that might affect you, we ask Canterbury City council, which is typically the planning authority for Tankerton.
Does being near the sea make a difference to air source heat pumps in Tankerton?
It can. Tankerton is within about 1 mile of the coast, and salt air speeds up corrosion on outdoor units. We site outdoor units out of the worst of the sea wind where possible and can suggest models with corrosion protection where the manufacturer offers it.
How much does an air source heat pump cost?
Air-to-water installations cost £8,000–£16,000 (0% VAT on homes), before the grant. Air-to-air prices are set after a survey, and we confirm the VAT on the quote.
When will I hear back?
On the same working day you contact us. After that, we agree a survey, diagnosis or installation date that suits you, with a fixed price before work starts.
Do you work in Tankerton?
Yes. We work in Tankerton and the rest of Kent, within the London and South East area we cover. To book, phone us on 07833 053749 or send an email.
Is there a survey before the work?
Yes, every time. We diagnose before we treat: the survey tells us what the job needs and how to do it, and the quote is based on that.
Why use an F-Gas certified company?
Certification shows a business is approved to work on systems that hold F gas refrigerant. In Great Britain, that certification is a legal requirement, not an optional extra, and we hold it.
System by system
Hot water cylinders
Existing cylinders may not be suitable for a heat pump and we tell you if it needs replacing.
Air-to-air heat pumps
Since 2025, air-to-air heat pumps can also be permitted development in England, subject to the conditions. A unit used solely for cooling isn’t covered and need a check with the council.
Also near Tankerton
Also in Tankerton
Heat pumps in Tankerton: local notes
Tankerton lies within about 1 mile of the sea. For a heat pump near the sea, ask about any coastal protection option the manufacturer offers. The 2021 Census found about 80% of households in detached or semi-detached houses. Houses usually have space for an outdoor unit and a hot water cylinder.
If your home is near Whitstable station and heated by a gas boiler, an air-to-water heat pump can replace it where the survey shows it suits. Period properties close to Church of All Saints can suit a heat pump, though insulation and any heritage protection are checked first.
Tankerton is about 1 mile north-east of Whitstable, in Kent. We cover Tankerton for air source heat pumps, along with the rest of Kent. Our area takes in 922 places across Kent, large and small. Bromley, roughly 45 miles off, has its own page on this site.
Our working area takes in CT5, every street of it. From Gann Road, Clare Road and Athol Road to the smaller roads in between, the whole area is covered. Close by, we work in Swalecliffe (1 mile east), Chestfield (1 mile south-east), Whitstable (1 mile south-west), Radfall (2 miles south-east) and West End (2 miles south-east). Within a short drive, we also cover Canterbury (6 miles south), Margate (15 miles east), Sittingbourne (14 miles west) and Faversham (8 miles south-west).
What’s near Tankerton
In Tankerton, that means homes and buildings near The Whitstable School and Monument Public House. Tankerton’s nearest station is Whitstable station, about 0.7 miles south-west. Nearby you’ll also find Whitstable and Tankerton Hospital (within half a mile south-east) and Tankerton Castle (0.5 miles west). Green spaces nearby include West Blean and Thornden Woods.
Before you call an engineer
Some faults have simple causes you can check first: check the mode, the set temperature, the remote’s batteries and the breaker. If the breaker trips a second time, leave it off and call 07833 053749 or email us.
Owner care supports servicing; it does not replace it. Simple care keeps the air moving through the system, but the refrigerant circuit, the electrics and the parts you can’t see still need an engineer at the interval the manufacturer recommends.
How the visit works
Where something has to be switched off during the work, we agree it with you first, so you can plan around it. In a business, work can often be done one area at a time. The work takes a few days for most air-to-water installations, with air-to-air systems often quicker. A few pictures let us plan a visit to a place like Tankerton.
- We find out about your home and the heating you have now.
- Every room’s heat loss is worked out on site.
- We design the system, check the radiators and cylinder and look at the outdoor unit position.
- A fixed-price quote explains the cost, the grant position and the VAT.
- We install, commission and register the system under MCS.
Before we arrive
- Unlock any gate, garage or side passage we need
- Dig out any previous service or F-Gas records
- Clear the space around the indoor unit, or where it will go
Getting a price
To help us quote: where the property is and what kind of building it is, pictures of the rooms or units, the brand and model of anything already fitted and any symptoms, from error codes to drips. Once you have those, call us on 07833 053749, or email if that’s easier.
Read more
What air conditioning will not do
We’ll always give you a straight diagnosis, so here’s what air source heat pumps won’t do:
- Grants for hybrid systems or replacements of low-carbon systems
- Planning approval where permitted development does not apply
- Formal advice on VAT for your situation
If in doubt, ring us on 07833 053749 or write to us at info@aircondoctor.co.uk and we’ll say what we think before booking.
Where we work
- Air-to-air heat pumps
- Hot water cylinders
- Underfloor heating
- Air-to-water heat pumps
- Radiator systems
- Homes heated by oil, LPG or gas
A customer’s words
“Very professional from the initial survey through to installation. The engineer explained everything clearly and the quote was exactly what we paid. Would not hesitate to recommend AirCon Doctor.”
David W., Haywards Heath