Hampshire · Heat pump installation
Heat pump installers in Redenham
F-Gas certified and NICEIC approved, we cover Redenham for MCS certified installation of air source heat pumps for heating and hot water, with the Boiler Upgrade Scheme grant applied for. Fixed-price quotes and a 24/7 emergency line.
- Deciding which kind of heat pump suits the home
- Checking eligibility for a heat pump grant
- Radiators that may be too small for a heat pump
Your questions about air source heat pumps in Redenham
Do I need planning permission for a heat pump in Redenham?
It depends on the property. Central Redenham sits inside the Appleshaw Conservation Area. A heat pump on a house can be permitted development if it meets the conditions, including the MCS noise check, but not within the grounds of a listed building, and in a conservation area the outdoor unit can’t face a road. Where necessary, we check with the local planning authority (for Redenham, normally Test Valley council).
Will you come out to Redenham?
Yes, smaller places are covered as well as towns. Visits to smaller places are planned so the engineer arrives with what the job needs.
How do you keep the place clean during the work?
We put dust sheets over floors and furniture near the work first, and we tidy up as we go. Before we leave, we clear up and run through the work with you.
Will my radiators work with a heat pump?
It varies from room to room. The survey compares each radiator with the room’s needs and the quote shows what’s needed.
Does servicing affect my warranty?
For some brands, yes. Send us the make and model and we’ll tell you what the manufacturer expects and stick to the interval they set.
What’s the price of a heat pump installation?
£8,000–£16,000 (0% VAT on homes) for air-to-water, before the grant. The final price depends on the heat loss survey, the radiators and the cylinder and the quote is fixed.
Is there a survey before the work?
Yes. Photos often do the job for simple work, while larger systems and faults that need testing are seen on site.
How we handle air source heat pumps in Redenham
As an MCS certified installer, we fit air source heat pumps for homes in Redenham and the rest of Hampshire. There are two kinds: air-to-water, which heats radiators or underfloor heating and your hot water, and air-to-air, which warms rooms through indoor units and can also cool. We help you work out which suits your home. If you are dealing with checking eligibility for a heat pump grant and moving away from fossil-fuel heating, we can sort it out.
Space for an outdoor unit is rarely an issue near Redenham, so the design comes down to heat loss, radiators and hot water.
The records are your system’s health record: a dated account of the work and the readings we took. If anything goes wrong later, it helps the next engineer and the manufacturer and it’s worth keeping safe.
- Location
- Redenham (SP11)
- Wider area
- Hampshire
- Certified
- NICEIC and F-Gas, MCS
- Quote
- Fixed after a survey or pictures
- Typical price
- £8,000–£16,000 (0% VAT on homes), before the grant
- Telephone
- 07833 053749
- Last updated
- 30 October 2026
Managing agents and facilities teams in Redenham
Landlords, letting agents and managing agents book us, not only the people who live or work in the property. Let us know who will give us access and who the records should go to and we’ll copy in whoever needs it.
From a single flat to a whole estate, the approach is the same: a look at the job first, a fixed-price quote, work booked with the occupier and written records afterwards.
What the work involves, system by system
Hot water cylinders
Cylinder size is based on your household’s needs.
Air-to-air heat pumps
Air-to-air heat pumps warm rooms through indoor units and can cool them in summer. They don’t heat hot water, so that has to come from elsewhere.
How we price air source heat pumps
Some jobs are bigger than they look, and some smaller. What affects the quote:
- The pipe route between the units
- What we find on the survey or diagnosis
- A single visit or a regular plan
No two properties are the same, so we price each one individually. The equipment, how we reach it, the route between units and the work needed all make a difference.
Before you get in touch
Simple jobs can often be priced from photos and some basics. Useful things to send:
- A close-up of the unit’s label showing the model number
- Wide pictures of the room or the existing unit
- Where the property is and what kind of building it is
Our prices page gives typical ranges, but your quote is based on your job, because no two buildings, rooms or systems are the same. Once we have looked at the job, from photos or on a survey, you get a fixed price. To start, give us a ring on 07833 053749.
Air source heat pumps in Redenham: the local picture
VOA council tax data show about 43% of homes in and around Redenham were built in 2000 or later, and the 2021 Census found about 60% of households in detached or semi-detached houses. Better insulated, newer homes are often a good match for a heat pump. Finding room for the outdoor unit and a cylinder is seldom a problem in homes like these.
Every heat pump design starts with a room-by-room heat loss calculation. Older homes near Church of St Peter in the Wood may need extra checks for planning and heat loss before a heat pump is designed.
Redenham is about 4 miles north-west of Andover, in Hampshire. Anywhere in SP11, our engineers can take on air source heat pumps. Redenham is one of 683 towns, villages and districts in Hampshire where we work for homes and businesses. For properties nearby, see our Guildford page, about 43 miles away.
If your postcode is in SP11, the property is within reach. Places around Redenham that are also on our list: Appleshaw (1 mile south-east), Faberstown (1 mile west), Clanville (1 mile east), Chute Forest (2 miles north) and Fyfield (2 miles south). Within a short drive, we also cover Andover (4 miles south-east), Tidworth (4 miles west), Whitchurch (10 miles east) and East Anton (5 miles east).
Near you in Redenham
Around Redenham, our work takes us to homes and businesses near Walnut Tree Inn. For rail, the closest station is Andover station, roughly 4 miles south-east of the centre. Nearby you will also find Ludgershall Castle (2.6 miles north-west) and Andover War Memorial Hospital (3.8 miles south-east). Green spaces nearby include Quarley Hill and Anton Lakes.
What happens on the day
Our engineers bring the tools, gauges and access equipment the job needs. All we ask is clear access to the units, or to where they’ll go, and to the consumer unit. The visit takes from a couple of days to around a week, depending on the system and how much of the heating changes. We plan the trip to Redenham around you.
- It begins with your house and the heating it relies on now.
- Every room’s heat loss is worked out on site.
- We design the system, check the radiators and cylinder and look at the outdoor unit position.
- You get a fixed price, with any grant and the VAT set out.
- Installation, commissioning and MCS registration complete the job.
Preparing for the visit
- Make sure we can reach the consumer unit or fuse board
- Make sure someone can let us in at the agreed time
- Give us access to the outside wall, roof or yard where the outdoor unit sits
Getting a quote
Some jobs can be priced from pictures, while others need a survey. Multi-room systems, commercial buildings and anything with a long or hidden pipe route are normally surveyed first. Either way, the quote is fixed before anything goes ahead.
Read more
Nearby places to Redenham
Also in Redenham
A customer’s words
“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”
Sarah M., East Grinstead