Greater London · Heat pump installation
Heat pump installation in Beam Park, Greater London
Air source heat pumps in Beam Park from an F-Gas certified company, with warranty terms explained brand by brand. Enquiries answered the same working day.
- Radiators that may be too small for a heat pump
- Planning and permitted development questions
- Moving away from fossil-fuel heating
Air source heat pumps for homes and businesses in Beam Park
Every installation starts with a heat loss survey. That tells us how much heat the home needs, room by room, so the heat pump and the radiators or indoor units can be sized properly. Guesswork leads to systems that are too big or too small. If the problem is moving away from fossil-fuel heating and checking whether planning permission is needed, we can help.
In a flat in Beam Park, the lease and the freeholder normally decide where a heat pump can go. The planning rules for flats are stricter than for houses, so we check the position before we design.
Nothing is signed off by word of mouth: commissioning details and F-Gas records for a new system, a note of the fault and the fix for a repair, or a service record. Keep it with the system’s paperwork, because it helps with any later warranty question.
- Place
- Beam Park (RM13, RM10, RM9)
- Region
- Greater London
- Certified
- F-Gas certified company, NICEIC approved, MCS
- Pricing
- A fixed-price quote up front
- Typical price
- £8,000–£16,000 (0% VAT on homes), before the grant
- Replies
- Same working day
- Telephone
- 07833 053749
- Page updated
- 30 October 2026
Air source heat pumps around Beam Park
Valuation Office Agency council tax records show about 43% of homes in Beam Park and the neighbourhoods around it were built in 2000 or later. Better insulated, newer homes are often a good match for a heat pump. London homes can be short of space for an outdoor unit and cylinder, which affects the choice of heat pump.
Historic houses such as Rainham Hall, about 1 mile south-east, are a reminder that listed homes need consent before a heat pump goes in. Period properties close to Church of St Helen and St Giles can suit a heat pump, though insulation and any heritage protection are checked first.
Beam Park is about 1 mile south of Dagenham, in Greater London. Whether you’re in the middle of Beam Park or further out, our engineers cover air source heat pumps, from small jobs to large ones. Our area takes in 764 places across Greater London, large and small. The nearest of our city pages is London, around 11 miles from Beam Park.
Our nearest recent job to Beam Park was on Greenwich High Road, Greenwich (SE10), about 8 miles south-west: installing a Mitsubishi Electric wall-mounted unit in the retail area and a second unit in the stockroom and office.
That includes properties on New Road, Lowen Road and Manser Road and nearby roads. Postcode districts we cover here: RM13, RM10 and RM9. Nearby, we also cover air source heat pumps in Hornchurch Marshes (1 mile south-west), South Hornchurch (1 mile north-east), Dagenham Green (1 mile west), Dagenham (1 mile north) and Rainham (1 mile east). Within a short drive, we also cover London (11 miles west), City of Westminster (14 miles west), Marylebone (14 miles west) and St Pancras (12 miles west).
Near you in Beam Park
Around Beam Park, our work takes us to homes and businesses near Beam Valley Country Park, The Bell pub and Brook Sixth Form and Academy. The closest station to Beam Park is Dagenham Dock station, about 1 mile west of the centre. A little further out are The Brewery (3.6 miles north) and Erith Museum (3 miles south). Open spaces near Beam Park include Dagenham Village Churchyard.
Nearby places to Beam Park
Other services in Beam Park
Owner checks or an engineer?
For air conditioning, cleaning the indoor unit’s filters is the main job owners can do where the manufacturer’s manual explains how. They come out, get a gentle clean and go back only when they’re dry. On a heat pump, the equivalent is keeping the outdoor unit clear and checking the controls.
There are a few things you can safely do yourself: keep the outdoor unit clear of leaves, plants and clutter, check the settings and the remote, and follow the cleaning the manual describes. Opening up the units, the electrics and the refrigerant circuit are a job for us.
Questions from Beam Park
Can I have air conditioning in a flat in Beam Park?
Often, yes, but the lease and the freeholder usually have a say. Permitted development rules for flats are tighter than for houses, so we check the outdoor unit position and give you the details to send to the freeholder or managing agent.
Is the heat pump grant available in Beam Park?
Beam Park is covered, as the scheme runs across England and Wales. The amount depends on the type of heat pump, and the survey confirms which applies. The installer applies, and we’re MCS certified.
Should I choose air-to-water or air-to-air?
Air-to-water feeds your central heating and hot water, while air-to-air warms and cools rooms directly. With air-to-air, hot water needs another source and the survey helps decide.
Can I do the refrigerant work myself?
No, not the refrigerant side. Under the F-gas rules, it must be done by qualified engineers from a certified company, and a new circuit is notifiable under Part P unless a registered electrician, such as a NICEIC approved contractor, does it.
Whose job is it to check the system for leaks?
The F-gas rules share it between the equipment’s operator and the engineers who work on it. The interval depends on the refrigerant charge, measured in tonnes of CO2 equivalent: at least yearly for 5 to under 50 tCO2e, and every 6 months for 50 to under 500 tCO2e.
Is the equipment covered by a warranty?
It’s the manufacturer’s warranty, which varies by brand. Daikin, for example, gives a standard 2 years on split air conditioning and we explain the terms for your brand on the quote.
Will you work on another installer’s system?
Yes. Systems fitted by other companies are fine, on all the main brands. Send us the make and model, and any records you have.
Different systems, different jobs
Air-to-water heat pumps
An air-to-water heat pump costs £8,000–£16,000 (0% VAT on homes), before the grant. Eligible homes in England and Wales can get a £7,500 Boiler Upgrade Scheme grant towards it and the installer applies.
Outdoor unit position and planning
Flats have tighter limits, and an Article 4 direction can remove permitted development rights. Listed building consent is a separate matter, and we check the position for your property.
How it works
Testing is the last part of the visit wherever the system can be switched on. Then we show you what we’ve done and answer any questions, and anything that needs a follow-up is pointed out there and then. All told, the work takes a few days on site, depending on the cylinder, the radiators and the pipework involved. The more we can see beforehand, the smoother the visit to Beam Park will be.
- It begins with your house and the heating it relies on now.
- A heat loss survey is carried out, room by room.
- The design covers the heat pump, emitters, hot water and outdoor unit.
- Cost, grant and VAT appear on one fixed-price quote.
- Then it’s fitted, commissioned and registered with MCS.
Before we arrive
- Plan for pets to be kept clear during the visit
- Have the make and model of any existing unit to hand
- Name a contact who can meet us at the agreed time
Getting a price
Our prices page gives typical ranges, but your quote is based on your job, because no two buildings, rooms or systems are the same. Once we have looked at the job, from photos or on a survey, you get a fixed price. To get going, call 07833 053749.
Related advice
Rented and managed buildings
Landlords, letting agents and managing agents book us, not only the people who live or work in the property. Let us know who will give us access and who the records should go to and we will copy in whoever needs it.
Where a tenant occupies the property but the landlord owns the system, it’s worth checking the agreement for who looks after the system. We can quote either party and send the records to whoever needs them.
From one of our customers
“Office air con broke down in the July heatwave. Called at 8am, engineer was here by noon and fixed within 2 hours. Brilliant emergency response. They now hold the service contract for the whole building.”
James T., Crawley, office manager