Hampshire · Air conditioning repair

Air conditioning repair in Soake, Hampshire

Air conditioning repair, for Soake and the surrounding area. Call for a fixed-price quote, and we’ll reply the same working day.

  • A suspected refrigerant leak
  • A noisy indoor or outdoor unit
  • A unit blowing warm air

Air conditioning repair across Soake

How the visit works

Each visit follows the same order: check the plan with you, put the dust sheets down, do the work, check the system and explain it all to you. On site, the work takes anything from an hour or so to a full day, depending on the fault and the parts. Work in Soake is booked in advance at a time that suits you.

  1. We start with what the unit is doing, the make and any code.
  2. The engineer diagnoses the fault on site, testing rather than guessing.
  3. You get the cause explained and a fixed price for the repair.
  4. With your go-ahead, we carry out the repair, recording any refrigerant work.
  5. We test the system in operation and leave you a note of the fault and the fix.

Before we arrive

  • Let us know where the consumer unit is
  • Move furniture away from the wall where we’ll be working
  • Let us know where we can park and unload

Ask for a quote

VAT is set out clearly on every quote, and the rate that applies to your job is stated. VAT can differ between homes and businesses and between kinds of work, so we confirm it in writing rather than guess. To get one, phone us on 07833 053749 or send an email.

Get a quick quote

Advice

Air conditioning repair in Soake, done properly

Think of it as a doctor’s appointment for your air conditioning: diagnose the cause, treat it properly and sign it off when it’s working. Guessing is expensive, and replacing a board when the fault is a sensor leaves the problem in place. The work covers ceiling cassettes, heat pumps and multi-split systems, and people most often call us about a fault code on the display and a suspected refrigerant leak.

A visit to Soake is planned so we can normally finish in one go, though some parts have to be ordered from the manufacturer.

Any work on the refrigerant circuit is recorded: the work carried out, the refrigerant involved and the quantities. Keep the records with the manual and the warranty documents, ready for the next service or a warranty query.

Location
Soake (PO7)
Wider area
Hampshire
Typical price
From £75 + VAT call-out
Certified
NICEIC approved, F-Gas certified
Price
Fixed, in writing
Phone
07833 053749
Page updated
30 October 2026

Your questions about air conditioning repair in Soake

Do you cover smaller places like Soake?

Yes. Soake is within the area we cover across London and the South East. Send a few details and photos, and we reply the same working day.

Who do I call if my air conditioning fails in Soake out of hours?

Yes. Our 24/7 emergency line covers Soake. Say what the system is doing and whether it shows a code, and we will advise on the next step.

Why is my air conditioning showing a fault code?

Each manufacturer uses its own codes, and one code can have more than one cause. Send us a photo of the display with the make and model and we’ll test the system to confirm the cause.

How much is an air conditioning call-out?

A diagnosis call-out is from £75 + VAT. Once we know the cause, you get a fixed price for the repair before any work goes ahead. The cost depends on the fault, the parts and access to the units.

Can you still repair R410A air conditioning?

Yes. Any leak is repaired before recharging, and the work is recorded and we will give you an honest view on whether it’s worth it.

Why use an F-Gas certified company?

For refrigerant work, both the engineer and the company need the right F-gas credentials. It’s worth checking before you book and we will gladly show you ours.

Do you survey before quoting?

Yes, every time. We diagnose before we treat: the survey tells us what the job needs and how to do it and the fixed price is built on it.

What the work involves, system by system

Multi-split systems

Refrigerant leaks on a multi-split can be anywhere on several pipe runs. We test each run to find it before the system is repaired, tested and recharged.

Circuit boards and sensors

Circuit boards and temperature sensors control how the system runs. A failed sensor can make a unit stop, run oddly or show an error code and boards can fail with age or after electrical problems.

Safe owner checks

On air conditioning, the filters in the indoor unit are normally the one part owners can clean, if the manual says so. With the power off, they lift out, can be vacuumed or rinsed and must be fully dry before they go back. For a heat pump, the main owner jobs are a clear outdoor unit and sensible control settings.

Leave the units and pipework where they are. Disconnecting a system means dealing with refrigerant, which only a qualified engineer can do, and the electrical side needs a competent person. Ask us to quote for a move instead.

Air conditioning repair in Soake: the local picture

The last census (2021) found about 74% of households in detached or semi-detached houses. Tell us where your outdoor unit is and how to reach it, so we can plan the visit. At about 59 miles from central London, Soake sits inside the area we cover across London and the South East.

A photo of the error code and the unit’s rating label helps us plan the repair. When cooling fails at a school like Denmead Junior School, we can time non-urgent repair work around lessons.

Soake is about 1 mile north-west of Waterlooville, in Hampshire. Our engineers cover Soake for air conditioning repair, along with the rest of Hampshire. Count every place we list in Hampshire and you reach 683, with Soake on the list. The nearest of our city pages is Worthing, around 29 miles from Soake.

Our nearest recent job to Soake was on East Street, Chichester (PO19), about 12 miles east: installing a Daikin wall-mounted unit in the dining area and a second unit serving the kitchen pass area.

Whether you’re on Soake Road and Hambledon Road or anywhere close by, our engineers can take on the work. If your postcode is in PO7, we can take the job on. We also cover the places around Soake: Furzeley Corner (1 mile south-west), Hart Plain (1 mile east), Cowplain (1 mile east), Waterlooville (1 mile south-east) and Purbrook Heath (2 miles south). Further out, we also cover Gosport (8 miles south-west), Havant (4 miles south-east), Eastleigh (14 miles west) and Fareham (7 miles south-west).

What’s near Soake

Typical jobs here are in properties near The Mead End pub and The Cowplain School. Soake’s nearest station is Bedhampton station, about 3.7 miles south-east of the centre. A little further out are Clanfield Earthwork (4.7 miles north-east) and Queen Alexandra Hospital (3.2 miles south). Green spaces nearby include Southmoor Nature Reserve and Portsdown Hill.

Map of Soake © OpenStreetMap contributors

Honest limits

Some problems need a different service or another trade:

  • A supply fault outside the property
  • A discontinued model with no parts available
  • A leak on an old R22 system

If in doubt, call 07833 053749 or fill in the contact form and we’ll say what we think.

What we work on in Soake

  • Ceiling cassettes
  • Multi-split systems
  • Ducted systems
  • Heat pumps
  • VRF systems
  • Wall-mounted split systems

What a customer said

“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”

Sarah M., East Grinstead

F-Gas certified companyRefrigerant work done and recorded properly
NICEIC approvedElectrical work certified
MCS certifiedHeat pump installations
Checkatrade memberVetted trade directory
24/7 emergency lineBased in East Grinstead