Medway · Heat pump installation
Air Source Heat Pumps in Meresborough
Expert air source heat pumps for Meresborough: diagnosis first, then a fixed-price quote, the work and written records. Ask us for a fixed-price quote.
- Comparing heat pump types
- A boiler that’s getting old
- Working out where a cylinder could go
Owner checks or an engineer?
Good habits make our visits easier, not unnecessary. Simple care keeps the air moving through the system, but the refrigerant circuit, the electrics and the parts you can’t see still need an engineer at the interval the manufacturer recommends.
Write down what you notice: error codes, noises, drips, smells or a drop in performance. It makes our diagnosis quicker, and a photo of the display helps even more.
Air source heat pumps in Meresborough, done properly
Many air source heat pumps can be installed as permitted development in England, without a planning application. The conditions include an outdoor unit of no more than 1.5 m³ and compliance with MCS 020(a), and the unit cannot be used solely for cooling or sit within the curtilage of a listed building. We check the rules for your property as part of the survey. If you’re dealing with working out whether radiators need upsizing and ageing boilers that will need replacing, we can sort it out.
If your home in or near Meresborough is heated by oil, LPG or electric heaters with no mains gas, the Boiler Upgrade Scheme adds an extra £1,500 until March 2027 for an air source or ground source heat pump, on top of the £7,500.
Think of the paperwork as the system’s health record: a dated account of the work and the readings we took. If anything goes wrong later, it helps the next engineer and the manufacturer and it’s worth keeping safe.
- Location
- Meresborough (ME8)
- Wider area
- Medway
- Approvals
- NICEIC and F-Gas, MCS
- Guide price
- Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
- Quote
- A fixed-price quote up front
- Call
- 07833 053749
- Last updated
- 30 October 2026
Homes in Meresborough and heat pumps
At about 3 miles from the coast, Meresborough is close enough for sea air to matter. Coastal sites are worth mentioning at the survey, as salt air affects the outdoor unit and its fixings. The last census (2021) found about 48% of households in terraced houses. In a terrace, the outdoor unit position and the MCS noise check need particular care. Meresborough’s centre falls inside the Meresborough Conservation Area. In the mile around Meresborough’s centre, 2 conservation areas have been designated. About 4 listed entries lie within half a mile of central Meresborough, Hollytree Cottage (grade II) among them. Where a home is affected, the outdoor unit position is settled with the local planning authority (normally Medway council) before the heat pump design is finished.
Every heat pump design starts with a room-by-room heat loss calculation. Period properties close to St Paul's Church can suit a heat pump, though insulation and any heritage protection are checked first.
Meresborough is about 2 miles south-east of Gillingham, in Medway. Properties in Meresborough get the same service as everywhere we cover: a look at the job first, a fixed-price quote and written records at the end. Across Medway, we cover 68 places, and Meresborough is one of them. Bromley, roughly 26 miles off, has its own page on this site.
We cover every part of the ME8 postcode area and the roads nearby. Close by, we work in Rainham (1 mile north), Moor Street (1 mile north-east), Hartlip (1 mile east), Yelsted (1 mile south) and Lower Hartlip (1 mile east). Further out, we also cover Chatham (4 miles west), Rochester (6 miles north-west), Strood (7 miles north-west) and Luton (4 miles north-west).
Around Meresborough
In Meresborough, that means homes and buildings near Howard School, Foxburrow Wood and Leigh Academy Rainham and the streets around them. The nearest railway station is Rainham (Kent) station, roughly 1.3 miles north of the centre. A little further out are Medway Maritime Hospital (3.7 miles north-west). The countryside around Meresborough includes Detling Hill and Bishop Saltings.
Meresborough questions
Is Meresborough within the area you cover?
Yes, and the size of the place makes no difference to how we work. Send a few details and photos, and we reply the same working day.
Is the heat pump grant available in Meresborough?
Yes, if the home and the heat pump meet the scheme’s rules: Meresborough is in England, where it applies. It gives £7,500 towards an air-to-water or ground source heat pump, or £2,500 towards an air-to-air heat pump that replaces the fossil-fuel heating and meets the whole home’s heating need. As an MCS certified installer, we apply for it on your behalf.
Who is responsible for leak checks?
The operator of the equipment, working with qualified engineers. Systems below 5 tCO2e fall outside the set leak check intervals, while larger ones need checks at least every 12 months, or every 6 months from 50 tCO2e. We can tell you which band your system falls into.
How long does a heat pump installation take?
As a guide, it takes from a couple of days to around a week, depending on the system and how much of the heating changes. We plan the work so you’re without heating for as little time as possible and agreed before work begins.
Why does F-Gas certification matter?
Companies working on equipment that contains F gas must be certified by an approved body, and each engineer needs the right qualifications too. It means the refrigerant in your system is handled legally.
How quickly will you reply?
The same working day. Then we agree a date that works for you, with a fixed price before work starts.
Do I get paperwork after the visit?
Yes. It’s the record a manufacturer or the next engineer will ask to see: the date, the work, and any refrigerant added or recovered.
Rented and managed buildings
Managing agents often deal with us directly. Send the address, what’s needed and how access works, and we will send a fixed-price quote.
Whether it’s one property or many, the approach is the same: a look at the job first, a fixed-price quote, work booked with the occupier and written records afterwards.
What happens on the day
Anything involving refrigerant is handled by F-Gas qualified engineers, as the law requires, and electrical work is done by us as NICEIC approved contractors. On the day, both are in the same hands. The work takes from a couple of days to around a week, depending on the system and how much of the heating changes. Somewhere like Meresborough, it helps to know about lanes, gates and where to park.
- First we talk through the property and the current system.
- We measure heat loss for every room.
- The design covers the heat pump, emitters, hot water and outdoor unit.
- Cost, grant and VAT appear on one fixed-price quote.
- We install, commission and register the system under MCS.
How to prepare
- Tell us about parking and loading
- Let us know if the units are on a roof, a high wall or in a locked area
- Let us know where the consumer unit is
How to get a quote
The quickest way to a quote is to send pictures: the room or the existing unit, the outside wall or roof where the outdoor unit sits or would go, and the label on any existing unit. Add the address and what you’d like done, and simple jobs can often be priced without a visit.
Related advice
Nearby places to Meresborough
What else we do in Meresborough
System by system
Air-to-air heat pumps
Air-to-air heat pumps warm rooms through indoor units and can cool them in summer. They don’t heat hot water so you’ll need another way to heat it.
Hot water cylinders
An older cylinder may not suit a heat pump, and we explain whether yours can stay.
What a customer said
“Office air con broke down in the July heatwave. Called at 8am, engineer was here by noon and fixed within 2 hours. Brilliant emergency response. They now hold the service contract for the whole building.”
James T., Crawley, office manager