West Sussex · Heat pump installation

Heat pump installation in Kilnwood Vale, West Sussex

Air source heat pumps across Kilnwood Vale and nearby, from the first look to the final check with the price fixed before work begins.

  • Not knowing whether a grant applies
  • Working out where a cylinder could go
  • Deciding which kind of heat pump suits the home

Air source heat pumps for Kilnwood Vale

Air source heat pumps in Kilnwood Vale, done properly

Many air source heat pumps can be installed as permitted development in England, without a planning application. The conditions include an outdoor unit of no more than 1.5 m³ and compliance with MCS 020(a), and the unit cannot be used solely for cooling or sit within the curtilage of a listed building. We look at the planning position for your home during the survey. Common call-outs are for replacing a combi boiler with a heat pump and working out whether radiators need upsizing, across homes heated by oil, LPG or gas, hot water cylinders and air-to-water heat pumps.

Older and listed homes in villages like Kilnwood Vale need extra care, because permitted development doesn’t apply within the grounds of a listed building, so consent comes first.

Looking after a system is mostly common sense: clear space around the outdoor unit, the cleaning the manual describes and a service at the recommended interval. It also keeps you on the right side of any warranty terms that ask for servicing.

Location
Kilnwood Vale (RH12, RH11)
Wider area
West Sussex
Response
Answered the same working day
Quotes
Fixed after a survey or photos
Prices
Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
Approvals
F-Gas certified company, NICEIC approved, MCS
Telephone
07833 053749
Updated
30 October 2026

System by system

Hot water cylinders

Cylinder size is based on your household’s needs.

Air-to-air heat pumps

Since 2025, air-to-air heat pumps can also be permitted development in England, subject to the conditions. Cooling-only units are not included, so check with the council.

Homes in Kilnwood Vale and heat pumps

About 28 miles out from central London, Kilnwood Vale is part of the South East area we work across. About 55% of households live in terraced houses, according to the 2021 Census. In a terrace, the outdoor unit position and the MCS noise check need particular care.

If you live near Faygate station, the survey compares air-to-water and air-to-air for your home before anything is quoted. Older homes near St Francis' Church may need extra checks for planning and heat loss before a heat pump is designed.

Kilnwood Vale is about 1 mile south-west of Bewbush, in West Sussex. We cover Kilnwood Vale for air source heat pumps, along with the rest of West Sussex. Our West Sussex coverage runs to 371 places, and Kilnwood Vale is one of them.

The closest recent job we can point to from Kilnwood Vale was on Manor Royal Business District, Crawley (RH10), about 3 miles east: installing a Daikin VRV system serving six indoor cassette units across an open-plan office, two meeting rooms and a server room.

All of RH12 and RH11 is within our area, from busy streets to back roads. Kilnwood Vale sits on or near the A264, so getting to you is simple. We also cover the places around Kilnwood Vale: Faygate (1 mile west), Colgate (1 mile south), Broadfield (2 miles east), Roffey (3 miles south-west) and Handcross (3 miles south-east). Larger places within reach include Crawley (3 miles east), Horsham (4 miles south-west), Haywards Heath (9 miles south-east) and Burgess Hill (11 miles south-east).

Local landmarks in Kilnwood Vale

Around Kilnwood Vale, our work takes us to homes and businesses near Target Hill Park, Holy Trinity CofE Secondary School and Cottesmore School and the streets around them. The closest station to Kilnwood Vale is Faygate station, about 0.9 miles west. A little further out are County Mall (2.7 miles north-east) and Crawley Museum (2.7 miles north-east). For a walk, there’s Warnham LNR and Tilgate Lake.

Map of Kilnwood Vale © OpenStreetMap contributors

The process

Every visit follows the same order: check the plan with you, put the dust sheets down, do the work, test what we have done and talk you through it. The visit itself takes a few days on site, depending on the cylinder, the radiators and the pipework involved. Rural lanes and tight entrances are worth mentioning before a visit to Kilnwood Vale.

  1. We find out about your home and the heating you have now.
  2. We measure heat loss for every room.
  3. We design the system, check the radiators and cylinder and look at the outdoor unit position.
  4. Cost, grant and VAT appear on one fixed-price quote.
  5. We install, commission and register the system under MCS.

Getting ready for the visit

  • Keep pets out of the rooms we are working in
  • Tell us about access, such as roof hatches, high walls or locked plant areas
  • Make sure we can reach the consumer unit or fuse board

Getting a price

Need a price for air source heat pumps? Please phone 07833 053749 or use the quote form and tell us about the job. We will talk you through the options and give you a fixed-price quote before you commit to anything.

Get a price

Read more

Pricing air source heat pumps in Kilnwood Vale

You’ll get a fixed price before we start. It’s based on:

  • Whether it’s a simple split or a larger system
  • The condition of any existing system
  • The pipe route between the units

Our prices page shows typical ranges, but your price depends on the job in front of us. Call for a fixed-price quote, and we will talk you through it.

Asking for a quote

Before you ask for a quote, gather:

  • Where the outdoor unit is, or where you’d like it
  • The address and the type of property
  • Your installation or service records

Our prices page gives typical ranges, but your quote is based on your job, because no two buildings, rooms or systems are the same. After a look at the job, by photos or a survey, the price is fixed. To start, call 07833 053749.

What air conditioning won’t do

We will always give you a straight diagnosis, so here’s what air source heat pumps won’t do:

  • Planning decisions, which rest with the council
  • Disconnecting or servicing a gas boiler
  • Tax rulings, which only HMRC can give

Not sure which it is? You can call us on 07833 053749 or use the quote form and we’ll tell you honestly before you book.

What the work covers

  • Air-to-air heat pumps
  • Homes heated by oil, LPG or gas
  • Air-to-water heat pumps
  • Hot water cylinders
  • Radiator systems
  • Underfloor heating

Kilnwood Vale questions

Is the heat pump grant available in Kilnwood Vale?

Yes, if the home and the heat pump meet the scheme’s rules: Kilnwood Vale is in England, where it applies. The grant is £7,500 for an air source (air-to-water) heat pump and £2,500 for an air-to-air system that replaces the existing fossil-fuel heating. You do not apply yourself: the MCS certified installer does, which is us.

Will you come out to Kilnwood Vale?

Yes, smaller places are covered as well as towns. A few pictures and the postcode are enough to get things started.

Do you provide F-Gas records?

Yes, on every job. A new system comes with commissioning details, F-Gas records and the manufacturer’s warranty information, while repairs and services get a written note of what was found and done.

Do you survey before quoting?

Yes, always. Diagnosis comes before treatment: the survey shows what’s needed, where things go and what access we need, and the quote is based on that.

How long will it take to install a heat pump?

An installation takes several days for an air-to-water system with a new cylinder, less for an air-to-air system. We confirm the timing after the survey, and you can phone us on 07833 053749 or send an email to book it.

Which manufacturers do you install and repair?

We work with the leading brands, from Mitsubishi Electric, Daikin and Fujitsu to Panasonic, Toshiba, LG, Samsung, Mitsubishi Heavy Industries and Hitachi. Tell us the make and model and we will take it from there.

Are my radiators big enough for a heat pump?

It varies from room to room. The survey compares each radiator with the room’s needs and the quote shows what’s needed.

From one of our customers

“Office air con broke down in the July heatwave. Called at 8am, engineer was here by noon and fixed within 2 hours. Brilliant emergency response. They now hold the service contract for the whole building.”

James T., Crawley, office manager

F-Gas certified companyRefrigerant work done and recorded properly
NICEIC approvedElectrical work certified
MCS certifiedHeat pump installations
Checkatrade memberVetted trade directory
24/7 emergency lineBased in East Grinstead