Isle of Wight · Heat pump installation

Heat pump installation in Colwell, Isle of Wight

Air source heat pumps, in Colwell and nearby. Call for a fixed-price quote, and we will reply the same working day.

  • Checking eligibility for a heat pump grant
  • Radiators that may be too small for a heat pump
  • Working out where a cylinder could go

Air source heat pumps in Colwell

How we handle air source heat pumps in Colwell

An air-to-water heat pump heats water to a lower temperature than a typical boiler, so radiators may need to be larger to give out the same heat. The survey shows which rooms are fine and which need changes and anything that needs changing is in the quote. We’re often asked to deal with moving away from fossil-fuel heating and questions about where the outdoor unit can go, across air-to-air heat pumps, underfloor heating and homes heated by oil, LPG or gas.

In a place like Colwell, some homes are listed, because permitted development does not apply within the grounds of a listed building, so we check consent first.

Nothing is signed off by word of mouth: commissioning details and F-Gas records for a new system, a note of the fault and the fix for a repair, or a service record. File it with the manual so it’s to hand next time.

Location
Colwell (PO40, PO39)
Region
Isle of Wight
Approvals
F-Gas certified, NICEIC approved, MCS
Response
Same working day
Quotes
A fixed price before any work starts
Guide price
Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
Call
07833 053749
Updated
30 October 2026

How the visit works

The visit has three parts, a bit like a doctor’s appointment: diagnose, treat and sign off. First we check the system or the space against the plan, then the work itself, and finally everything is tested, recorded and explained. Most of the time goes on the middle part, which takes anything from a couple of days for air-to-air to the best part of a week for air-to-water with radiator changes. We plan the trip to Colwell around you.

  1. It starts with a conversation about the home, the existing heating and your plans.
  2. The survey measures heat loss room by room and looks at radiators, hot water and the best spot for the outdoor unit.
  3. You get a fixed-price quote, with any grant you’re eligible for and the VAT explained.
  4. We fit the outdoor unit and connect it to the heating, hot water and controls.
  5. The system is commissioned and registered under MCS, and we show you how to use it.

How to prepare

  • Dig out any previous service or F-Gas records
  • Make sure we can reach the consumer unit or fuse board
  • Tell us about any building rules, permits or sign-in

Get a fixed-price quote

Quotes do not take long. Send a few details and pictures, and we reply the same working day. If we need to see the property first, we book a survey at a time that works for you.

Ask for a quote

Read more

Colwell: your questions answered

Does the Boiler Upgrade Scheme cover homes in Colwell?

Yes, if the home and the heat pump meet the scheme’s rules: Colwell is in England, where it applies. The amount depends on the type of heat pump, and the survey confirms which applies. The installer applies, and we are MCS certified.

Does being near the sea make a difference to air source heat pumps in Colwell?

It can. Colwell is within about 1 mile of the coast, and salt air speeds up corrosion on outdoor units. The outdoor unit position, its fixings and regular servicing all help near the sea.

How much does an air source heat pump cost?

An air-to-water heat pump costs £8,000–£16,000 (0% VAT on homes) before the grant. The Boiler Upgrade Scheme offers £7,500 to eligible homes in England and Wales, and we confirm eligibility before you commit.

Can landlords and managing agents book you?

Yes. Homeowners, landlords, agents and businesses all book us across London and the South East. Let us know who the records should go to.

Do you work in Colwell?

Yes. Our area takes in London and the counties of the South East, Colwell included.

Which type of heat pump is right for my home?

Air-to-water replaces the boiler for heating and hot water, while air-to-air heats and cools rooms. The survey helps decide. We install both types.

Will I need planning consent for an air source heat pump?

It depends on the property and where the unit goes. Flats have different limits, conservation areas have extra conditions, and an Article 4 direction can remove the rights and we look at it during the survey.

Do you need air source heat pumps in Colwell?

Some homes heated by electric heaters or storage heaters consider a heat pump instead. A survey shows whether a heat pump suits the property and what would need to change, and we explain the grant position for your home.

Customers normally contact us after spotting something like this:

  • Deciding which kind of heat pump suits the home
  • Deciding on the outdoor unit position
  • Not knowing whether a grant applies

Older homes near Christ Church may need extra checks for planning and heat loss before a heat pump is designed.

What your quote should include

  • Whether the company is F-Gas certified, and whether you can check it
  • Whether the quote shows VAT clearly
  • What happens if the job turns out to be different on the day

How to choose an air conditioning engineer

Let and managed properties

Records are where property maintenance often slips. Each visit is written up, plus the F-Gas records where refrigerant is involved, so you can show what was done and when.

If you look after several properties, we can quote and plan the work across all of them. Each property gets its own records, so the files stay tidy.

What a heat pump looks like in Colwell

Colwell is within about 1 mile of the coast. Coastal sites are worth mentioning at the survey, as salt air affects the outdoor unit and its fixings. Central Colwell is inside a conservation area. So the heat pump survey asks two extra questions here: is the home listed, and is it inside a conservation area? The last census (2021) found about 71% of households in detached or semi-detached houses. Houses normally have space for an outdoor unit and a hot water cylinder.

Every heat pump design starts with a room-by-room heat loss calculation.

Colwell is about 5 miles south of Lymington, in the Isle of Wight. Our engineers cover Colwell for air source heat pumps, along with the rest of the Isle of Wight. Colwell is one of 125 places in the Isle of Wight where we work for homes and businesses. The nearest of our city pages is Worthing, around 51 miles from Colwell.

If you need air source heat pumps at a property on Colwell Chine Road, Heath Lane and Chine Close or a nearby road, our engineers can take on the work. We cover every part of the PO40 and PO39 postcode area and the streets around it. Neighbouring places we cover include Totland (1 mile south-west), Freshwater (1 mile south-east), Norton Green (1 mile north-east), Easton (1 mile south-east) and Afton (1 mile south-east). We also work in nearby towns such as Newport (10 miles east), Cowes (11 miles north-east), East Cowes (12 miles north-east) and Barton (11 miles east). For island and remote properties, a little more planning is needed, so mention it when you ask for a quote.

Around Colwell

In Colwell, that means homes and buildings near Colwell Bay Inn. The nearest railway station is Lymington Pier station, roughly 4.9 miles north of the centre. A little further out are Lymington New Forest Hospital (5.7 miles north) and Ferguson Family Museum (1.1 miles east). For a walk, there’s Tennyson Down and Lymington and Keyhaven Marshes Nature Reserve.

Map of Colwell © OpenStreetMap contributors

What affects the quote in Colwell

Some jobs are bigger than they look, and some smaller. The main factors:

  • The distance and route between the indoor and outdoor units
  • What electrical work the job needs
  • Whether we need access equipment for high-level work

Several rooms, units or sites on one quote often makes better use of the time. Tell us about everything you’d like looked at and we’ll price it together.

Helping us quote

The more you tell us, the more accurate the quote. When you get in touch, it helps to send:

  • The postcode and whether it’s a home, flat or business
  • The outdoor side of the property, including any roof or flat area
  • Any previous service or F-Gas records

The quickest way to a quote is to send photos: the room or the existing unit, the outside wall or roof where the outdoor unit sits or would go, and the label on any existing unit. Tell us the address and what you need, and many jobs can be priced from that.

A customer’s words

“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”

Sarah M., East Grinstead

F-Gas certified companyRefrigerant work done and recorded properly
NICEIC approvedElectrical work certified
MCS certifiedHeat pump installations
Checkatrade memberVetted trade directory
24/7 emergency lineBased in East Grinstead