West Berkshire · Heat pump installation
Heat pump installers in Chilton Foliat
Air source heat pumps for Chilton Foliat, from F-Gas certified engineers, with warranty terms explained brand by brand. We reply to enquiries the same working day.
- Wanting to stop using oil, LPG or gas for heating
- Deciding on the outdoor unit position
- Not knowing whether a grant applies
Homes in Chilton Foliat and heat pumps
Chilton Foliat is about 62 miles from central London, well within the area we cover from our base in East Grinstead.
With Ramsbury Manor about 4 miles west, it’s worth asking whether your own home is listed before planning a heat pump. Live in one of the older houses around Church of St Mary? Expect the survey to look closely at heat loss and at the building’s planning status.
Chilton Foliat is about 10 miles west of Newbury, in West Berkshire. Across the RG17 area, we can help with air source heat pumps. Our West Berkshire coverage runs to 155 places, and Chilton Foliat is one of them. For properties nearby, see our Guildford page (44 miles or so).
Whether you are on Popham Close, Stag Hill and Whitelocks Piece or anywhere close by, we can help. Jobs in RG17 are looked at, quoted and booked the same way as anywhere else. Other places close to Chilton Foliat include Leverton (1 mile south-east), Upper Eddington (1 mile south-east), Eddington (2 miles south-east), Hungerford (2 miles south-east) and Woodlands St Mary (3 miles north). Larger places within reach include Newbury (10 miles east), Thatcham (12 miles east), Speenhamland (9 miles east) and Lambourn (5 miles north).
What’s near Chilton Foliat
Typical jobs here are in properties near John O'Gaunt School. Chilton Foliat’s nearest station is Hungerford station, about 1.7 miles south-east of the centre. Open spaces near Chilton Foliat include Watts Bank.
Air source heat pumps in Chilton Foliat
A £2,500 grant is available for some air-to-air heat pumps, with conditions. The system must replace the existing fossil-fuel heating and meet the home’s full heating demand, it must be installed by an MCS certified installer, and it must be in a home, so an add-on next to a boiler is not eligible. If the problem is no space for a hot water cylinder and checking whether planning permission is needed, we can help.
Homes around Chilton Foliat normally have room outside for a heat pump, so the design comes down to heat loss, radiators and hot water.
Equipment warranty comes from the manufacturer, on its own terms, and we explain those terms on your quote. Terms differ from brand to brand, and we’re happy to talk you through them.
- Where
- Chilton Foliat (RG17)
- Wider area
- West Berkshire
- Credentials
- F-Gas certified company, NICEIC approved, MCS
- Price guide
- Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
- Quotes
- Fixed after a survey or pictures
- Telephone
- 07833 053749
- Checked
- 30 October 2026
Leave it or put it right?
If the emitters cannot give out enough heat, some rooms will not get warm enough. Checking and upsizing them as part of the installation avoids that. Planning ahead for a job in Chilton Foliat means we can bring everything needed.
Whatever the property, the quote works the same way: the equipment, the access, the work involved and the time it takes. Call for a fixed-price quote and we will explain each part.
What you get with us
- A reply the same working day
- F-Gas certified company
- 24/7 emergency line for breakdowns
- We diagnose before we treat
Take a look at how installs are priced or our accreditations and certificates.
Rented and managed buildings
From a single flat to a whole estate, the approach is the same: a look at the job first, a fixed-price quote, work booked with the occupier and written records afterwards.
Running several properties is easier with one contractor. Our area covers Greater London and the South East, so work at different addresses can be planned together and kept on a regular cycle.
Your questions about air source heat pumps in Chilton Foliat
Does the Boiler Upgrade Scheme cover homes in Chilton Foliat?
Chilton Foliat is covered, as the scheme runs across England and Wales. Whether your home qualifies, and for how much, depends on the type of heat pump and the heating it replaces. As an MCS certified installer, we apply for it on your behalf.
Can I fit a heat pump in Chilton Foliat without planning permission?
It depends on the property. The centre of Chilton Foliat is in the Chilton Foliat Conservation Area. On a house, an air source heat pump can often go ahead under permitted development, with an outdoor unit of no more than 1.5 cubic metres and an installation that meets MCS 020(a), which includes a noise check. Those rights don’t reach the grounds of a listed building, and conservation areas rule out walls or roofs facing a road. If that might affect you, we ask the planning department at West Berkshire council, usually the authority for Chilton Foliat.
How much time does a heat pump install need?
It takes from a couple of days to around a week, depending on the system and how much of the heating changes. The cylinder, the radiators and the pipework make the biggest difference and the timing is set out with your quote.
Will you make a mess?
We put dust sheets over floors and furniture near the work first, and we tidy up as we go. At the end, we clear up and show you what we have done.
Is the equipment covered by a warranty?
Warranty comes from the manufacturer and depends on the brand and product. Daikin, for example, gives a standard 2 years on split air conditioning, and we explain the terms for whichever brand you choose.
Do I need new radiators for a heat pump?
It varies from room to room. The survey compares each radiator with the room’s needs, so the quote covers any changes.
Can I do any of the installation myself?
Not the refrigerant work. Under the F-gas rules, it must be done by qualified engineers from a certified company, and a new electrical circuit is notifiable building work unless a registered competent person does it.
Nearby places to Chilton Foliat
What else we do in Chilton Foliat
How the job changes from property to property
The Boiler Upgrade Scheme
The Boiler Upgrade Scheme covers England and Wales: £7,500 for air-to-water and ground source, and £2,500 for air-to-air in limited cases. The application goes through the installer.
Air-to-water heat pumps
An air-to-water heat pump costs £8,000–£16,000 (0% VAT on homes), before the grant. A £7,500 grant may be available through the Boiler Upgrade Scheme for eligible homes and the installer applies.
How it works
On the day, we arrive at the time agreed with you and run through the plan before anything else. Floors and furniture near the work are covered with dust sheets, and the electrics are made safe before any panel comes off. On site, it takes anything from a couple of days for air-to-air to the best part of a week for air-to-water with radiator changes. Work in Chilton Foliat is booked in advance at a time that suits you.
- First, a chat about the property and your goals for the heating.
- We survey for heat loss and look at radiators, cylinder space and outdoor unit options.
- You get our view on the right type for the house, and on whether the Boiler Upgrade Scheme applies.
- The system is installed and connected to the controls.
- After commissioning, you get the MCS certificate and a handover.
How to prepare
- Mention any parking restrictions near the property
- Give us access to the outside wall, roof or yard where the outdoor unit sits
- Make sure someone can let us in at the agreed time
Ask for a quote
For air source heat pumps in Chilton Foliat, ring us on 07833 053749 or write to us at info@aircondoctor.co.uk. Let us know the type of property and what you need, and send a few photos if you can. Enquiries get a reply the same working day.
Related advice
From one of our customers
“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”
Sarah M., East Grinstead