Kent · CT4
Air conditioning in CT4
Air conditioning installation, repair, servicing and heat pumps across CT4, by an F-Gas certified, NICEIC approved company.
Areas within CT4
- Shalmsford Street
- Bridge
- Chilham
- Elham
- Chartham
- Petham
- Old Wives Lees
- Patrixbourne
- Heart's Delight
- Barham
- Chartham Hatch
- Shottenden
- Stelling Minnis
- Bekesbourne
- Kingston
- Bishopsbourne
- Bossingham
- Street End
- Woolage Village
- Bekesbourne Hill
- Derringstone
- Gravel Castle
- Molash
- Ottinge
- Waltham
- Wootton
- Denton
- Godmersham
- Marley
- Mystole
- Out Elmstead
- Pett Bottom
- Rhodes Minnis
- Shelvin
- Upper Hardres
- Womenswold
- Garlinge Green
- Lodge Lees
- Lower Hardres
- Lynsore Bottom
- Mountain Street
- Nackington
- Westwood
- Woolage Green
- Breach
- Anvil Green
- Canterbury
- Stuppington
Services in CT4
- Commercial air conditioning
- Air conditioning repair
- Air conditioning installation
- Heat pump installation
- Air conditioning servicing
- See all services
To book a survey or ask a question, ring us on 07833 053749 or write to us at info@aircondoctor.co.uk.
Districts next door
More in Kent
All places in Kent
Areas we cover
Air conditioning in CT4: how it works
A new system normally needs a dedicated circuit from the fuse board. Adding a new circuit is notifiable building work under Part P unless it’s done by a registered competent person, and as NICEIC approved contractors we can install and certify it as part of the job. The work covers multi-split systems, wall-mounted split systems and air-to-air heat pumps, and common reasons people get in touch are rooms heated by plug-in heaters and not knowing which system, size or brand to choose.
Wherever the system can be run before we leave, we run it and check it in operation. Then we explain what was done and answer your questions, and anything that needs a follow-up is pointed out there and then. All told, the work takes anything from a day for one room to several days for a multi-room or ducted system.
- We start by looking at the rooms, the walls and where the outdoor unit can go.
- Each room is sized and you get a fixed-price quote setting out the equipment and the unit positions.
- The indoor unit is fixed in place, the outside unit positioned, and the connecting runs put in tidily.
- Power is wired in, the joints are proved leak-tight under pressure and a vacuum pump draws out air and moisture.
- The system is commissioned and checked in every mode, and we hand over the controls, F-Gas records and warranty information.
How we quote
One room or a whole building, we price it on the same basis: the work involved, the access and the equipment. The price is fixed before any work starts, and the quote sets out the VAT.
What you get with us
- One contact for properties across the South East and London
- Mitsubishi Electric, Daikin, Fujitsu, Panasonic, Toshiba and more
- Enquiries answered the same working day
- Electrical work covered by our NICEIC approval
Ask for a quote
Every quote shows the VAT clearly, and the rate that applies to your job is stated. VAT can differ between homes and businesses and between kinds of work, so we confirm it on the quote. For a fixed-price quote, phone us on 07833 053749 or use the quote form.
What’s near Shalmsford Street
Locally, jobs take us to houses, flats and workplaces close to Broadham Down, Chartham Primary School and Church of St Mary, among other places. Shalmsford Street’s nearest station is Chartham station, roughly 0.5 miles north of the centre. A little further out are Chilham Castle (2.6 miles west) and Whitefriars Shopping Centre (3.3 miles north-east). Not far away are Blean Woods RSPB Reserve.
Where we install in CT4
Planning rules are the same across England, CT4 included: an air-to-air system that heats as well as cools can be permitted development on a house, but cooling-only units, listed buildings and outdoor units facing a road in conservation areas need more care.
Across London and the South East, we reply to enquiries the same working day, and our emergency line is open 24/7.
Shalmsford Street: Close to Chartham station? A small study or box room used for work can typically be cooled with a single indoor unit. If your home is in one of the older streets near Church of St Mary, it’s worth checking whether it’s listed or in a conservation area before an install.
System by system
Outdoor unit positions
On flats and terraced houses, space outside is often the deciding factor. Every option is checked on the survey and we flag any consent you may need.
Pipework and condensate drains
We pressure test and evacuate the pipework before the system is charged, so the system starts life clean, dry and leak-tight. The results go into the commissioning records.
Looking after it afterwards
Simple habits make a real difference. Our advice:
- Keep to the service interval the manufacturer recommends
- Tell us if the unit starts to leak, rattle or show a code
- Wash or vacuum the filters as the manual describes
- Close windows and doors while the system is cooling
Before we leave, the system is commissioned and tested in each mode. Once it’s running properly, we take you through the controls and settings, so you’re confident using it.
Keep the outdoor unit clear. Leaves, plants, bins and stored items around it restrict the airflow, which makes the whole system less efficient.
What air conditioning cannot fix
Some problems need a different service or another trade:
- A building fabric problem such as single glazing or no loft insulation
- An installation that needs consent nobody has given yet
- Problems with a gas boiler or the radiators
For landlords and property managers
Records are where property maintenance often slips. Each visit produces a dated record, with F-Gas records wherever refrigerant work is involved, so you can show what was done and when.
Whether it’s one property or many, you get the same standard: a look at the job first, a fixed-price quote, work booked with the occupier and written records afterwards.
Common questions in CT4
Where does the outdoor unit go?
Wall brackets, ground level and flat roofs are all options, chosen for the pipe route, airflow and access. We also think about noise near bedrooms and neighbours and position can affect planning.
Will I get records for the system?
Yes. Every visit is written up, and any work on the refrigerant circuit goes in the F-Gas records. File them with the system’s paperwork.
Will you make a mess?
We start with protection: sheets over the floor and nearby furniture. Any drilling is agreed with you first, and we clear up the dust and offcuts when we finish.
Do you offer maintenance contracts?
Yes. We offer maintenance contracts, with visits at the interval your system and the manufacturer need. Each visit is written up and F-Gas records kept where they apply.
What does it cost to install air conditioning?
Single-room systems start from £1,200 + VAT and are typically up to £2,200 + VAT. The price includes supply, installation, commissioning and F-Gas documentation and is fixed after a survey or from pictures.
How long does air conditioning installation take?
It takes about a day for a single-room system, longer for multi-room and ducted systems. The survey tells us how long your installation will need so there are no surprises.
When will I hear back?
The same working day. Then we agree a date that works for you, with a fixed price before work starts.