East Sussex · Heat pump installation
Heat pump installation in Bishopstone, East Sussex
Our engineers work in Bishopstone on MCS certified installation of air source heat pumps for heating and hot water, with the Boiler Upgrade Scheme grant applied for. Diagnosis first, a fixed price and proper paperwork when we finish.
- Radiators that may be too small for a heat pump
- A boiler that’s getting old
- Deciding on the outdoor unit position
Air source heat pumps for homes and businesses in Bishopstone
Every installation starts with a heat loss survey. It shows how much heat each room needs on a cold day, so the heat pump and the radiators or indoor units can be sized properly. Sizing by rule of thumb isn’t good enough. The work covers homes heated by oil, LPG or gas, radiator systems and air-to-air heat pumps, and the jobs we see most are plans to switch to electric heating with a heat pump and checking emitters for a heat pump.
Space for an outdoor unit is rarely an issue near Bishopstone, so the design focuses on heat loss and radiators.
We’re an F-Gas certified company, NICEIC approved for electrical work, MCS certified for heat pumps and a Checkatrade member. Our engineers hold the F-gas qualifications needed to work on refrigerant.
- Place
- Bishopstone (BN25)
- Region
- East Sussex
- Approvals
- F-Gas certified company, NICEIC approved, MCS
- Price
- A fixed price before we start
- Typical price
- £8,000–£16,000 before the grant, 0% VAT on homes
- Phone
- 07833 053749
- Checked
- 30 October 2026
What we do, step by step
On the day, we arrive at the time agreed with you and check the plan with you first. Dust sheets go down over floors and anything close to the work, and the electrics are made safe before any panel comes off. The work itself takes a few days on site, depending on the cylinder, the radiators and the pipework involved. Photos of the existing unit help with repairs and servicing in Bishopstone.
- We find out about your home and the heating you have now.
- We measure heat loss for every room.
- From those figures we size the heat pump and decide on radiators, cylinder and outdoor position.
- You get a fixed price, with any grant and the VAT set out.
- Then it’s fitted, commissioned and registered with MCS.
Getting ready for the visit
- Make sure we can reach the consumer unit or fuse board
- Make sure we can reach the outdoor unit, or where it will go
- Keep pets and children away from the work area
How to get a quote
Photos are enough for some jobs; others need a visit first. Multi-room systems, commercial buildings and anything with a long or hidden pipe route are normally surveyed first. Either way, you get a fixed price before any work is booked.
Related advice
What affects the quote in Bishopstone
Before we fix a price, we need to know a few things. We check:
- What state the existing equipment is in
- The size of the job
- The pipe route between the units
What you pay reflects the actual work. That is why we look at the job first, from pictures or on a survey, and why the quote is fixed before any work starts.
Before you get in touch
You do not need the technical terms. Just send:
- The outdoor side of the property, including any roof or flat area
- The fuse board and where it is in the property
- Any previous service or F-Gas records
To help us quote: where the property is and what kind of building it is, a few pictures, the brand and model of anything already fitted and any symptoms, from error codes to drips. Once you have those, phone 07833 053749 or email us.
Nearby places to Bishopstone
More services for Bishopstone
Heat pumps in Bishopstone: local notes
At about 1 mile from the coast, Bishopstone is close enough for sea air to matter. Salt air is hard on outdoor units, so a heat pump near the sea needs a sensible position and regular checks, and some models offer corrosion protection for coastal sites. The last census (2021) found about 83% of households in detached or semi-detached houses. Houses normally have space for an outdoor unit and a hot water cylinder. Bishopstone’s centre falls inside the Seaford (Bishopstone) Conservation Area. Draw a one-mile circle round the middle of Bishopstone and it takes in 2 conservation areas. Listed buildings are part of the picture here: about 10 within half a mile of the centre, such as Church of St Andrew (grade I). That affects heat pumps: listed buildings need consent, and conservation areas limit where the outdoor unit can go under permitted development. Where needed, we check with Lewes council, typically the planning authority here.
Period properties close to Church of St Andrew can suit a heat pump, though insulation and any heritage protection are checked first.
Bishopstone is about 1 mile north-west of Seaford, in East Sussex. We cover Bishopstone for air source heat pumps, along with the rest of East Sussex. Our list for East Sussex has 289 entries and Bishopstone is among them. For properties nearby, see our Eastbourne page (9 miles or so).
Our nearest recent job to Bishopstone was on Corsica Road, Seaford (BN25), about 1 mile south-east: installing a marine-grade Daikin wall-mounted unit in the main living area.
We cover every part of BN25. If you need air source heat pumps at a property on Bishopstone Road and Manor Yard or anywhere close by, we can help. If you’re just outside Bishopstone, we cover Norton (1 mile north), Tide Mills (1 mile south-west), Seaford (1 mile south-east), Denton (1 mile north-west) and Newhaven (2 miles west). Within a short drive, we also cover Eastbourne (9 miles east), Lewes (7 miles north-west), Hailsham (9 miles north-east) and Uckfield (12 miles north).
Local landmarks in Bishopstone
Locally, jobs take us to houses, flats and workplaces close to Castle Hill, UTC@Harbourside and St Peter's School and the streets around them. The nearest railway station is Bishopstone (Sussex) station, roughly 0.8 miles south. Other landmarks nearby include Arlington Castle (3.9 miles north-east) and Chailey Heritage Marine Hospital (1 mile south-west). Open spaces near Bishopstone include Firle Beacon.
Looking after it afterwards
Once we have finished, these simple steps help:
- Find out the grant position at the survey
- Keep radiators clear
- Keep to regular servicing
After commissioning, the installation is registered under MCS and you receive the certificate. Keep it with the manufacturer’s paperwork for future reference.
Keep insulation and draught-proofing in good order, as lower heat loss means the system has less to do.
Do you need air source heat pumps in Bishopstone?
An ageing boiler is often the moment people start thinking about a heat pump. Planning the change before the boiler fails gives you time to survey, design and apply for any grant, rather than rushing a replacement in winter.
What we’re most often called about:
- Moving away from fossil-fuel heating
- Comparing heat pump types
- Finding a place for the outdoor unit
If you live near Bishopstone (Sussex) station, the survey compares air-to-water and air-to-air for your home before anything is quoted.
Questions to ask before booking
- Whether the company is F-Gas certified, and whether you can check it
- Whether extra work needs your approval first
- Whether the quote is a fixed price
FAQs for Bishopstone
Will you come out to Bishopstone?
Yes. Bishopstone is within the area we cover across London and the South East. Send a few details and photos, and we reply the same working day.
Does the Boiler Upgrade Scheme cover homes in Bishopstone?
Yes, the scheme covers homes in England, including Bishopstone, if they qualify. It gives £7,500 towards an air-to-water or ground source heat pump, or £2,500 towards an air-to-air heat pump that replaces the fossil-fuel heating and meets the whole home’s heating need. The installer applies, and we are MCS certified.
Who is responsible for leak checks?
The F-gas rules share it between the equipment’s operator and the engineers who work on it. How often depends on the size of the refrigerant charge in tonnes of CO2 equivalent: at least yearly for 5 to under 50 tCO2e, and every 6 months for 50 to under 500 tCO2e.
Are my radiators big enough for a heat pump?
Some radiators may be fine as they are, and some may need to be larger. At the lower temperatures a heat pump uses, radiators need more surface, and the survey checks each one.
How soon will you get back to me?
We reply to enquiries the same working day. For a breakdown that cannot wait, call our 24/7 emergency line.
What does an air-to-water heat pump cost?
For air-to-water, it’s £8,000–£16,000 (0% VAT on homes) before any Boiler Upgrade Scheme grant. Air-to-air prices are set after a survey, and we confirm the VAT on the quote.
What warranty do I get?
The manufacturer provides it, on its own terms. Some brands make regular servicing a condition so it’s worth keeping the service records.
What a customer said
“Excellent service from start to finish. Two wall-mounted units installed in our home. Clean, tidy work: they protected all the floors and left no mess. The systems work brilliantly. Would highly recommend.”
Sarah M., East Grinstead