Hampshire · Heat pump installation

Heat pump installation in Balmerlawn, Hampshire

Air source heat pumps in and around Balmerlawn, from a site survey or diagnosis to sign-off with the price fixed before work begins.

  • Wanting to stop using oil, LPG or gas for heating
  • Checking eligibility for a heat pump grant
  • Comparing heat pump types

Air source heat pumps in Balmerlawn

What we do, step by step

You don’t need to do much on the day. Someone needs to let us in and show us the units, or where they’re going, and the rest is down to us. At the end, we tidy up and run through the work with you. Photos of the room and the outside of the property help us plan a visit to Balmerlawn.

  1. We start with your plans and the property.
  2. We survey for heat loss and look at radiators, cylinder space and outdoor unit options.
  3. We explain which type of heat pump suits the home and whether a grant could apply.
  4. Installation follows on the agreed dates.
  5. The job ends with commissioning, the MCS certificate and a walk through the controls.

Preparing for the visit

  • Mention any roof access, ladders or high-level work
  • Let us know where we can park and unload
  • Clear the space around the indoor unit, or where it will go

Getting a price

Published ranges are a starting point; the quote is built on your property, because no two buildings, rooms or systems are the same. After a look at the job, by photos or a survey, the price is fixed. To get going, phone us on 07833 053749 or fill in the contact form.

Ask for a quote

Advice

How we handle air source heat pumps in Balmerlawn

An air-to-water heat pump heats water to a lower temperature than a typical boiler which means some radiators may need upsizing. We check each radiator against the room’s heat loss and anything that needs changing is in the quote. If the problem is moving away from fossil-fuel heating and questions about the Boiler Upgrade Scheme, we can help.

For a home around Balmerlawn that is off mains gas and heated by oil or LPG, the Boiler Upgrade Scheme adds an extra £1,500 until March 2027 for an air source or ground source heat pump, on top of the £7,500.

Some manufacturers make regular servicing by a qualified engineer a condition of their warranty. If that applies to your system, booking the service on time keeps the record straight and each visit is recorded.

Location
Balmerlawn (SO42)
Region
Hampshire
Guide price
Air-to-water £8,000–£16,000 before any grant (0% VAT for homes)
Price
Fixed, in writing
Response
Answered the same working day
Credentials
NICEIC and F-Gas, MCS
Phone
07833 053749
Page updated
30 October 2026

When to call us in Balmerlawn

People also ask about air-to-air heat pumps because they heat and cool. They warm rooms directly through indoor units, and can cool them when it’s hot. Whether a grant applies depends on the scheme conditions.

What we’re most often called about:

  • Plans to switch to electric heating with a heat pump
  • Not knowing whether a grant applies
  • Replacing a combi boiler with a heat pump

If you live near Brockenhurst station, the survey compares air-to-water and air-to-air for your home before anything is quoted.

What to look for in a quote

  • Which VAT rate the quote uses, and why
  • Whether extra work needs your approval first
  • Whether the electrical work is done by a registered contractor, such as NICEIC approved

Questions to ask before booking

What affects the quote in Balmerlawn

The quote reflects the job in front of us. We take into account:

  • Whether it’s a simple split or a larger system
  • One-off work versus a regular service cycle
  • The size of the job

A single unit or a whole estate, we price it on the same basis: what needs doing, how we get to it and what it needs. The price is fixed before any work starts, and the quote sets out the VAT.

Asking for a quote

To help us quote quickly, please include:

  • Your consumer unit or fuse board
  • The remote or wall controller showing any error
  • The outdoor side of the property, including any roof or flat area

Every quote starts with a look at the job, either on a site survey or, for simple jobs, from your photos and details. After that, we send a fixed price before any work starts.

Air source heat pumps in Balmerlawn: the local picture

The last census (2021) found about 84% of households in detached or semi-detached houses. Detached and semi-detached houses typically have room for the outdoor unit and a cylinder.

Historic houses such as Beaulieu Palace House, about 4.9 miles east, are a reminder that listed homes need consent before a heat pump goes in.

Balmerlawn is about 5 miles north of Lymington, in Hampshire. We cover Balmerlawn for air source heat pumps, along with the rest of Hampshire. Our list for Hampshire has 683 entries, and Balmerlawn is one. Worthing, roughly 51 miles off, has its own page on this site.

Every address in SO42 is within our area, from the main roads to the quietest streets. We also cover Brockenhurst (1 mile south-west), Setley (1 mile south), South Weirs (2 miles south-west), Lyndhurst (3 miles north) and Emery Down (3 miles north). Within a short drive, we also cover Eastleigh (14 miles north-east), Totton (7 miles north), Chandler's Ford (13 miles north-east) and Hedge End (13 miles north-east).

Around Balmerlawn

Around Balmerlawn, our work takes us to homes and businesses near Rose And Crown Hotel and the streets around them. The closest station to Balmerlawn is Brockenhurst station, about 0.9 miles south-west of the centre. A little further out are Lymington New Forest Hospital (4 miles south).

Map of Balmerlawn © OpenStreetMap contributors

Honest limits

Some problems need a different service or another trade:

  • Tax rulings, which only HMRC can give
  • Improving the building’s insulation
  • Promising eligibility for the Boiler Upgrade Scheme

If you are not sure, just call us on 07833 053749 and we will give you a straight answer before you book.

What we work on in Balmerlawn

  • Underfloor heating
  • Radiator systems
  • Homes heated by oil, LPG or gas
  • Air-to-water heat pumps
  • Air-to-air heat pumps
  • Hot water cylinders

Your questions about air source heat pumps in Balmerlawn

Do I need planning permission for a heat pump in Balmerlawn?

That depends on the building and where the outdoor unit goes. Historic England lists about 4 buildings and structures within half a mile of the centre of Balmerlawn. A heat pump on a house can be permitted development if it meets the conditions, including the MCS noise check, but not within the grounds of a listed building, and in a conservation area the outdoor unit can’t face a road. Where needed, we check with the local planning authority (for Balmerlawn, usually New Forest council).

Is Balmerlawn within the area you cover?

We do. Villages and hamlets get the same service as the bigger towns. A few pictures and the postcode are enough to get things started.

Am I eligible for a heat pump grant?

Quite possibly. The scheme runs in England and Wales and pays £7,500 towards an eligible air-to-water or ground source heat pump, or £2,500 for an air-to-air system that meets stricter conditions. Until March 2027 there’s an extra £1,500 for air source or ground source heat pumps in homes on oil or LPG with no mains gas. We check your home against the rules at the survey.

Why use an F-Gas certified company?

The law says any company working on equipment containing F gas has to be certified, and the engineers need their own qualifications. It means the refrigerant in your system is handled legally.

How do you keep the place clean during the work?

We start with protection: dust sheets over floors and anything close to the work. Any drilling is agreed with you first, and we clear up the dust and offcuts before we leave.

Who is responsible for leak checks?

The F-gas rules share it between the equipment’s operator and the engineers who work on it. How often depends on the size of the refrigerant charge in tonnes of CO2 equivalent: at least yearly for 5 to under 50 tCO2e, and every 6 months for 50 to under 500 tCO2e.

Will my radiators work with a heat pump?

That depends on the room’s heat loss and the radiator’s size. We check them all during the survey and the quote shows what’s needed.

A customer’s words

“Very professional from the initial survey through to installation. The engineer explained everything clearly and the quote was exactly what we paid. Would not hesitate to recommend AirCon Doctor.”

David W., Haywards Heath

F-Gas certified companyRefrigerant work done and recorded properly
NICEIC approvedElectrical work certified
MCS certifiedHeat pump installations
Checkatrade memberVetted trade directory
24/7 emergency lineBased in East Grinstead